Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Light (red)
5 TIMER Indicator Light (green)
6 SWING Indicator Light (orange)
(VERTICAL SWING)
7 SWING Indicator Light (orange)
(HORIZONTAL SWING)
●If the TIMER indicator light flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See page 17 Auto Restart).
8Intake Grille (Fig. 3)
9 Air Filter
0 UP/DOWN Air Direction Flaps
A RIGHT/LEFT Air Direction Louvers (behind UP/DOWN Air Direction Flaps)
B Drain Hose
Fig. 4 Outdoor Unit
CIntake Side D Outlet Side E Pipe Unit
Fig. 5 Remote Control Unit
FSLEEP Button
GMASTER CONTROL Button
HSET TEMP./SET TIME Buttons () I Signal Transmitter
J TIMER Button
K FAN CONTROL Button L START/STOP Button M Battery compartment lid
Inside of the battery compartment lid (Fig. 6)
NAIR FLOW DIRECTION Button O ENERGY SAVE Button
P CODE CHANGE (Slide Switch)
Switching the remote control unit code. (Max. 4 units)
Q TIME ADJUST Button R TEST RUN Button
●This button is used when installing the air conditioner and should not be used under normal conditions as it will cause the air conditioner’s thermostat function to oper- ate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the indoor unit’s OPERA- TION indicator light and TIMER indicator light will begin to flash simultaneously.
●To stop the test operation mode, either press the TEST RUN button once again, or press the START/STOP button to stop the air conditioner.
SACL Button
TRemote Control Unit Display (Fig. 7) U Transmit Indicator
V Clock Display
W Operating Mode Display X Timer Mode Display Y Fan Speed Display
Z Temperature Set Display [ Timer Set Indicator
\ Temperature Set Indicator