To install only ScanSnap Manager, click the [Customize] button to show the [Custom install on "(volume_ name)"] window, and clear the [ABBYY FineReader for ScanSnap] and [Cardiris] checkboxes.

You cannot install "ABBYY FineReader for ScanSnap" or "Cardiris" only.

DThe installation is started.

DThe Cardiris installation window appears.

10.Scroll down and read the "License" to the end. Then, click the [Continue] button.

DA confirmation message window appears.

11.Click the [Agree] button.

DThe [Select Destination] window appears.

DBy default, Cardiris is installed in the Applications Folder.

12.Click the [Continue] button.

DThe [Installation Type] window appears.

13.Confirm that [Easy Install] is specified in the [Installation Type] pop-up menu.

14.Click the [Install] button.

DThe installation is started.

DThe [Finish Up] window appears.

15.Click the [Quit] button.

DThe [Startup item registration] window appears.

16.Click the [OK] button.

DWhen the installation is complete, the [Installation completed successfully] window appears.

17.Click the [Close] button.

18.Remove the Setup DVD-ROM from the DVD-ROM drive.

DSoftware installation is complete. Proceed to "Con- necting the ScanSnap" (page 5).

Connecting the ScanSnap

Connect the ScanSnap after the desired software has been installed.

Only one ScanSnap can be connected to a computer at a time.

1. Select the power cable type according to power source for the ScanSnap.

zTo use the ScanSnap at a fixed location

Use the power cable (*) to connect to an AC out- let.

For details about the connection, refer to "Using the Power Cable" (page 6) in Step 3.

*: Combination of the AC adapter and AC cable

AC Cable

AC

Adapter

zTo use the ScanSnap in a remote location with your laptop computer or a place without AC outlets available nearby

Use the USB bus power cable for power supply from your computer.

For details about the connection, refer to "Using the USB Bus Power Cable" (page 6) in Step 3.

USB Bus

Power Cable

CAUTION

Do not use AC adapters other than the one supplied with this ScanSnap. Doing so may cause damage to the ScanSnap.

Manufacturer: LEI

Model No.: NU13-1072166-I3

2. Remove the tape seal covering the USB connector and power connector of the ScanSnap.

5