Fujitsu Siemens Computers A3120 manual Inserting Expresscards, Removing Expresscards

falcon2.book Page 39 Thursday, December 21, 2006 10:30 AM

INSERTING EXPRESSCARDS

There are two different width ExpressCards: 34 mm and 54 mm. The connector inside the slot is located on the left-hand side of the slot. If you insert a 34 mm card, align it with the left side of the slot when inserting it.

ExpressCards are inserted in the ExpressCard slot (the top slot). (Figure 4-8).

ExpressCard

ExpressCard	ExpressCard Slot
Eject Button	(top slot only)

Figure 4-8. inserting/Removing ExpressCards

■Inserting or removing an ExpressCard during your notebook’s shutdown or bootup process may damage the card and/or your notebook.

■Do not insert an ExpressCard into a slot if there is water or any other substance on the card as you may permanently damage the card, your notebook, or both.

You may be required to log on as Adminis- trator or a member of the Administrator’s Group to complete this procedure. If your computer is connected to a network, net- work policy settings may also prevent you from completing this procedure.

See your ExpressCard manual for instructions on the insertion of your card. Some cards may require that your notebook is off while inserting them.

To insert an ExpressCard, follow these steps:

1.Make sure there is no ExpressCard currently in the slot. If there is, see Removing ExpressCards.

2.If the eject button is extended, press it in until it clicks.

3.Insert your ExpressCard into the slot with the product label facing up. If you are inserting a 34 mm card, be sure to align it with the left side of the slot when inserting it.

4.Push the card firmly into the slot until it is seated in the connector.

U s e r I n s t a l l a b l e F e a t u r e s

REMOVING EXPRESSCARDS

See your ExpressCard manual for specific instructions on removing your card. Some cards may require your notebook to be in Standby Mode or Off during removal.

■Windows has a shutdown procedure for ExpressCards that must be followed before removing a card. (Review your operating system manual for the correct procedure.) It is good practice to remove devices using the Unplug or Eject Hard- ware icon in the Notification Area at the bottom right of the display.

■If the dialog box states that the device cannot be removed, you must save all of your open files, close any open applica- tions and shut down your notebook.

To remove an ExpressCard, follow these steps:

1.Unlock the card from the slot by pressing the eject button associated with the slot in which the card is located. When pressed, the button will pop out.

2.Firmly press the button again until it is flush with the notebook. This will eject the card slightly out of the slot allowing you to remove the card.

39