26
23. Choose HEADING ADJUST and then press the EDIT soft key.
HEADING ADJUST
▲
{
ON
~
OFF
▼
24. Choose ON and then press the ENTER soft key.
You have mounted the antenna unit facing straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead ahead visually should appear on the
heading line (zero degrees).
In practice, you will probably observe some small error on the display because of the
difficulty in achieving accurate initial positioning of the antenna unit. The following
adjustment will compensate for this error.
a) Set ship’s heading toward a suitable target (for example, ship or buoy) at a range betwe en
0.125 and 0.25 nautical mile.
b) Rotate the ENTER knob to bisect the target with the EBL and press the SET soft key.
c) Press the RETURN soft key.
d) As a final test, move the boat towards a small buoy and confirm that the buoy shows up dead
ahead on the radar when it is visually dead ahead.
25. The next step is to choose navigation data sources and calibrate navigation data. Press
the NEXT soft key to show the NAV SETUP menu.
POSITION SOURCE
FURUNO BB GPS
SPEED (STW) SOURCE
ETR
TEMPERATURE SOURCE
ETR
DETPH SOURCE
ETR
STW CALIBRATION
+00%
TEMP CALIBRATION
+00.0°F
DEPTH CALIBRATION
+00ft
WIND AVERAGING
001 seconds(s)
WIND DIRECTION OFFSET
S000.0°
WIND SPEED CALIBRATION
+00%
WIND (MWV) SOURCE
FURUNO BB GPS
STW TEMP
12.3 kt 56.3
°
F
WIND SPEED
1.2 kt WIND DIR
131
°
DEPTH
99.5ft
AIR TEMPERATURE SOURCE
FURUNO BB GPS
AIR PRESSURE SOURCE
FURUNO BB GPS
STW TEMP
12.3 kt 56.3
°
F
WIND SPEED
1.2 kt WIND DIR
131
°
DEPTH
99.5ft
Page 1 Page 2
Installation wizard, nav setup
26. Choose appropriate item and press the EDIT soft key.
27. Choose appropriate setting and then press the ENTER soft key. Refer to the table below
for description of each item.