![](/images/new-backgrounds/1272065/27206543x1.webp)
Entering transducer data by transducer specifications
To connect the transducers which are not programmed, do as follows:
Note: The transducers of 53 - 65 kHz, 111 to 139 kHz and 171 - 183 kHz cannot be connected to the
1.At the XDCR Setting dialog box, select "XDCR Select" and press the ENTER key. The following screen appears.
XDCR Type
Manual
2.Press T to select "Manual", and then press the ENTER key.
3.If a high frequency transducer is fitted, press T to select "HF Connection" and then press the ENTER key.
Connected
Not connected
4.Press S to select "Connected" and then press the ENTER key.
5.Press T to select "Freq" and then press the ENTER key.
---kHz
6.Press T or S to set the frequency of the transducer which is connected and then press the ENTER key.
7.Press T to select "Band width" and then press the ENTER key.
8.Press T or S to set the value for the bandwidth and then press the ENTER key. If the band- width is not entered manually, it is automatically set to 1/10 of the transducer frequency.
9.If a low frequency transducer is fitted, repeat steps 3 to 8. Note: Leave the "Tx Power" at "Auto".
10.Press and hold down the [ /BRILL] key to turn off the power.
3.3Speed/Water Temperature Sensor Calibration
If the optional speed and/or water temperature sensor is connected, set it up as follows:
1.Turn on the power and press the MENU key. The main menu and
2.Press T to select "System" and "Calib" and then press the ENTER key.
13