ACTIVE WEDGE

CP-AW1120, CP-AW2120

SPECIFICATIONS

 

 

 

CP-AW1120

CP-AW2120

Peak Power (Watts)

750

900

Rated Power (Watts)

250

300

Frequency Response

32Hz - 250Hz

32Hz - 250Hz

Low Pass Filter (Variable)

40Hz - 250Hz

40Hz - 250Hz

Tuning

Bass Reflex

Bass Reflex

Woofer Size

12”

Dual 12”

Fuse

25A

30A

Dimensions (mm)

567(l) x 415(w) x 384(h)

836(l) x 415(w) x 384(h)

 

22-5/16 x 16-11/32 x 15-3/32”

32-29/32 x 16-11/32 x 15-3/32”

DISCLAIMER

Always ensure the Active Wedge is securely attached, to avoid movement. FUSION accepts no responsibility for damage or injury in relation to inappropriate securing of this product.

CONTROL DESCRIPTIONS

LEVEL

This allows the adjustment of the amplifier level of the subwoofer. Turn clockwise to increase the level. If the sound becomes distorted reduce the level.

LOW PASS FILTER (LPF)

This allows the adjustment of the highest frequency the Active Wedge will produce. This should be adjusted to blend with your main speakers. Typically, this will be set to around 100Hz (approximately the central position of the control knob).

REMOTE LEVEL CONTROLLER

When connected, this allows further control over the level from a remote location, using the supplied lead.

INSTALLATION

Make sure the Active Wedge is firmly fixed in your vehicle. Check before drilling or cutting holes. DO NOT work near gas tanks, fuel lines, hydraulic lines or electrical wiring.

DO NOT mount the Active Wedge in such a way as to pinch or damage the wires.

Make sure everything is firmly connected, before attaching the +12V wire. Ensure the +12V wire is fused as close as possible to the battery. Always use a fuse with the recommended rating.

WIRING

Connect the ground wire to the vehicle first (clean dirt and paint to bare metal).

Connect the remote on (blue wire).

Connect the RCA cables if applicable, OR

Connect the speaker level wire by splicing into the headunits speaker wires. See Note 1 on reverse.

Connect the remote level controller with the supplied lead.

Connect the 12 volt (red wire) to the positive battery terminal.

Check all connections.

www.fusionelectronics.com

Page 1
Image 1
Fusion CP-AW2120, CP-AW1120 specifications Specifications, Disclaimer, Control Descriptions, Installation, Wiring