FCC compliance statement, General specifications | Fusion MS-IP700

SPECIFICATIONS

SPECIFICATIONS

FCC compliance statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

•this device may not cause harmful interference, and

•this device must accept any interference received, including interference that may cause undesired operation.

General specifications

Operating voltage	10.2–16 VDC negative ground
Fuse rating	15 amp
DVD player
Laser power	Class I
Power output
Maximum	70 W x 4
26 WRMS per channel at 4 ohms
45 WRMS per channel at 2 ohms
Pre-output voltage	3 VRMS

Auxiliary input sensitivity

The 700 Series AUX input sensitivity is 1V RMS when gain is set to 0dB.

•Increasing the gain by 6dB doubles the input sensitivity (0.5V RMS for same volume).

Tuning range

Europe and Australasia

FM radio frequency range 87.5– 108 MHz.

Frequency step 100 kHz

AM radio frequency range 522– 1620 MHz.

Frequency step 9 kHz

USA

FM radio frequency range 87.5– 107.9 MHz.

Frequency step 200 kHz

AM radio frequency range 530– 1710 MHz.

Frequency step 10 kHz

61

Image 62

Fusion MS-IP700 FCC compliance statement, General specifications, Auxiliary input sensitivity, Tuning range, DVD player

Contents

700 SERIES Manual MS-IP700MS-AV700 MARINE ENTERTAINMENT SYSTEM WARNINGS AND CAUTIONS USING iPodCare and Maintenance USB Flash Drives REGISTER YOUR PRODUCT ONLINE CONTENTS Support, Sales and Service INSTALLING THE 700 SERIESTroubleshooting Specifications Menu PowerUSER INTERFACE AND CONTROLS Tuner ROTARY ENCODER AND MENU KEY USING THE ROTARY ENCODER AND MENU KEY Adjusting levelsAccessing Menus GETTING STARTED To power the unit on or offOpening Control Screens ADJUSTING VOLUME LEVEL To adjust the volume level To mute and unmute the volume To set sub-woofer levels or tone ADJUSTING SUB-WOOFER LEVEL AND TONE 6. Press any key to exit SETTING AND CLEARING THE ALARM To set the alarmTo clear the alarm 1. Press the Brightness key. The Brightness screen is displayed To adjust the brightness of the display screen2. Turn the Rotary Encoder to adjust the brightness setting 3. Press any key to exit TUNER To select one of the available tuner bandsAM/FM/VHF Figure 2 - Example AM band input source screen To tune to a required frequency, channel or preset settings menu, see ‘Setting up VHF’ TuningWhen tuning with this method… Applies Note Up to 15 presets can be stored for each radio band To add a new presetTo remove one or more presets To set the squelch level Minimizing background noiseTurning scan mode on To turn scan mode on To listen to input from your iPod iPod Selecting tracks from a playlist CONTROLLING iPod PLAYBACK Controlling Playback keys. The selected track starts playing automatically Shuffle To change a setting in the iPod settings menuRepeat Searching Album artwork To listen to music from your USB flash driveSubtitles USB FLASH DRIVE Selecting audio tracks from USB flash drive For example, to select a Folder then track Controlling playback The selected track starts playing automatically Repeat mode is turned off Repeat the current selection To change a highlighted setting in the USB settings menu1. Press the Encoder to toggle the value on or off Random play shuffle is turned off To listen to input from an alternate auxiliary device AUXILIARY INPUT FUSION MS-NRX200 Remote Control ADDITIONAL FEATURES NMEA-2000 bus installation FUSION-only installation MS-AV700 model only DVD source selected DVD source not selected Figure 7 - Dimensions - top view INSTALLING THE 700 SERIESDimensions are in millimeters mm and inches ”. Not to scale Figure 8 - Dimensions - side view Figure 9 - Dimensions - front view CONNECTIONS ETHERNET CONNECTION ANTENNA REMOTE CONTROL NMEA2000 USB CONNECTIONBATTERY +12VDC ACCESSORY +12VDC NEGATIVE GROUND GND AMPLIFIER ON OUT ZONE 1 R RED INSTALLATION 700 SERIES CONNECTION EXAMPLE SETTING UP THE 700 SERIES Selecting and setting up a zoneEnabled To enable or disable the selected Zone Link to zone Volume controlTo enable or disable volume control To link Zone 2 level to Zone 1 level You can access the screen Volume limitTo specify the volume limit for the selected Zone Sub-woofer level When using your iPod with either model To enter the name for the selected Zone To insert your iPod or USB flash drive MS-IP700 modelBefore inserting iPod To connect your USB flash drive, you will need MS-AV700 modelTo connect your iPod, you will need 1. Press the door catch and open the door of the dock Supported iPod sleeves Connecting auxiliary deviceAdjusting Auxiliary input level audio quality Recommended settings are listed belowTo set the clock SiriusXM SATELLITE RADIO To select 12 or 24 hour clock display modeActivating your SiriusXM tuner To select a channel SiriusXM menu optionsChannels To select a Category Padlock iconCategory To enter Parental menu To change the Parental mode access codeParental mode Channel Locking / unlocking 3. Enter your access codeTo access a locked channel 1. Press the Menu key 2. Do one of the following To lock or unlock a channel Sub filter To enable or disable the key sound Power saveTo change the sub filter setting To enable or disable power saving mode To change the VHF region setting To change the Tel mute settingTo change the tuner region setting Tel mute To reset your 700 Series to factory default values Factory ResetTo enable or disable the AM of VHF tuner sources Sources Problem APPENDICESTROUBLESHOOTING Solution to update software when Apple releases new versions. If you My FUSION SPECIFICATIONS General specificationsTuning range Power output Japan VHF tuning rangeSUPPORT, SALES AND SERVICE LICENSING 700 Series INDEXINDEX auxiliary input settings presetsremote controls See troubleshooting tuner source screenssub-woofer level USB flash drive volume zonesPage Page Page Page Specifications and design are subject to change without notice P/N MAN000001E