| 6. Adjust the support frame to the desired height | |
| and secure with 8 screws. The length of the | |
| support frame can be adjusted in steps of | |
| 3/4 ´´/ 20 mm from 15 3/16 ´´/ 386 mm to | |
| 25 7/16 ´´/ 646 mm (Fig. 21). | |
| Note: | |
| ensure that the minimum distance between the | |
| hob and the extractor hood is maintained – | |
| 24 ´/ 600 mm for an electric hob and 30 ´/ 762 mm | |
| for a gas hob | |
| 7. Stainless steel ventilation ducts only | |
| (LK | |
| pull the protective film off the metal surface. | |
| 8. Place both ventilation ducts over the support | |
| frame. Take care not to scratch the sensitive | |
| duct surface. | |
| 9. Attach the electrical plug to the support frame | |
| with sticky tape so that it can be easily reached | |
Fig. 21 | later. | |
10. Hang the hood and the support frame with the | ||
| ||
| two | |
| (Fig. 22). | |
| Attention: the two screws cannot support | |
| the weight of the hood. Therefore it must be | |
| supported at this stage! | |
Fig. 22 |
| |
18 |
|