Gaggenau AH 590-720 manual 7 7/8 13 5/8

(7 7/8") 200

(13 5/8") 346

Fig. 19

Fig. 20

Note:

the extractor hood is to be installed to a kitchen ceiling or suspended ceiling. Ensure that the ceiling is capable of providing a firm hold for a maximum weight of hood and accessories of 60 kg.

Before marking the securing holes, make sure that no electricity wires or water pipes or other wires/ pipes are laid at the drilling points in the ceiling.

Before installation check the enclosed wall plugs and screws are suitable for your ceiling. If neces- sary use special wall plugs.

Installation:

1.Using the drilling template mark the position of the screws on the ceiling.

2.Drill 4 holes Ø 8 mm for the wall plugs. Push the plugs flush with the ceiling (Fig. 19).

3.Turn two screws to a 10 mm gap. Both screws are placed in a position, in which at a later stage of the installation the key-holes of the suppor- ting frame are found (namely front left and back right from the control panel of the hood).

4.Place the hood on a suitable base. Connect the air outlet pipe to the hood.

5.Screw the support frame to the hood with

4 screws. The marking “FRONT” must be on the same side as the control panel (Fig. 20).

Ventilation ducts LK 590-020/030/021/031 only: the enclosed extension module should be mounted on top of the support frame. Follow the above instructions for mounting the support frame and hood.

17