Programming the Remote
33
The AVR65 is equipped with a powerful remote control that will control not only the receiver’s functions, but also most CD players and cassette decks manufactured by Harman Kardon. For increased flexi- bility, the remote also contains the codes for most popular brands of audio and video equipment, including CD players, cassette decks, TV sets, cable boxes, VCRs, satellite receivers and other
Programming the Remote
As shipped from the factory, the remote is fully programmed for all AVR65 func- tions, as well as those of most Harman Kardon CD changers, CD players and cas- sette decks. In addition, by following one of the methods below, you may program the remote to operate a wide range of devices from other manufacturers.
Direct Code Entry
This method is the easiest way to program your remote to work with different products.
1.Use the tables in the following pages to determine the
2.Turn on the unit you wish to program into the AVR65 remote.
3. Press and hold both the Device Control Selector bfor the type of product to be entered (e.g., VCR, TV) and the Mute button dat the same time. Hold both buttons until the red light under the button stays lit. Note that the next step must take place while the red light is on, and it must begin within 20 seconds after the light illuminates.
4.Point the AVR65’s remote towards the unit to be programmed, and enter the first
5.If the device to be programmed in does NOT turn off, continue to enter the
6.Try all of the functions on the remote to make certain that the product operates. Keep in mind that many manufacturers use a number of dif- ferent combinations of codes, and it is a good idea to make certain that not only the Power control works, but the volume, channel and transport controls, as appropriate. If all func- tions do not work properly, you may need to use a different remote code.
7.If a code cannot be entered to turn the unit off, if the code for your product does not appear in the tables in this manual, or if not all functions oper- ate properly, try programming the remote with the Auto Search Method.
Auto Search Method
If the unit you wish to include in the AVR65’s remote is not listed in the code tables in this manual, or if the code does not seem to operate properly, you may wish to program the correct code using the Auto Search method as shown below.
1.Turn on the unit that you wish to include in the AVR65 remote.
2.Press the Device Control Selector bfor the type of product to be entered (e.g., VCR, TV) and the Mute button dat the same time. Hold both buttons until the red light under the button stays lit. Note that the next step must take place while the red light is on, and it must begin within 20 seconds after the light illuminates.
3.Point the AVR65 remote towards the unit to be programmed, and press and hold the Surround Mode
Selector yor the Sleep button `. This will send out a series of codes from the remote’s
AVR65 120 volt Rev (C) 10/6/98
