displayed in turn:

SELECT PRODUCT

 

HOT WATER

 

READY FOR USE

 

READY FOR

USE

 

 

 

 

•Place a cup and/or receptacle beneath the hot water/steam pipe (Fig.15).

•Turn the knob anticlockwise as shown in Fig.15.

•Dispense the desired quantity of hot water; to stop the flow of hot water turn the knob clockwise.

•Press the button (26) again; the machine will switch back to the normal operating mode and the display will show:

SELECT PRODUCT

READY FOR USE

9DISPENSING STEAM / PREPARING CAPPUC- CINO

Steam can be used to froth the milk for cappuccinos and also to heat beverages.

Scalding hazard! Splashing may occur at the start – scalding hazard! The hot water nozzle and pipe can reach high temperatures: avoid touching it directly with your

hands.

•When the machine is ready to dispense coffee, direct the steam pipe (14) above the drip tray, open the “hot water/steam” knob

(16)for a few instants to discharge any residual water from the steam pipe; soon only steam will issue from the nozzle. The display will show:

STEAM

•Turn the knob (16) to OFF.

•Fill 1/3 of the receptacle you wish to use to make cappuccino with cold milk.

For best results when making cappuccinos, the milk and the cup used should be cold.

•Immerse the steam nozzle into the milk to be frothed and turn the knob (16); turn the container slowly with up-down movements to achieve uniform frothing (Fig.16).

•After using the steam for the desired time, shut off the steam (16).

•The same method can be used to heat other beverages.

•Clean the steam nozzle with a damp cloth.

Note: Should you wish to use big cups, raise the side door and rotate the steam tube; by this way, the steam tube can be further raised (Fig. 17). This is particularly useful

ENGLISH

when you use the cappuccinatore.

10 OPTIONAL ACCESSORIES

10.1 Cappuccinatore

The cappuccinatore is a device that automatically froths milk, making it extremely easy to prepare classic Italian-

style cappuccino.

To install the cappuccinatore, proceed as follows:

•Make sure that no other devices are fitted on the steam tube; you must remove any devices that have been installed. I.E. the “Pannarello”.

•Loosen the ring nut without slipping it off the cappuccinatore.

•Insert the cappuccinatore in the steam tube to a depth of about 4 cm.

•Tighten the ring nut securely.

Note: if the ring nut is not securely tightened, the cappuccinatore may slip out during use.

Hot water with the cappuccinatore

To dispense hot water using the cappuccinatore, follow the directions provided in par.8; hot water will flow out of the lower part of the cappuccinatore.

• 31 •