Gaggia Espresso Machine 13 FUNCTION PROGRAMMING, ENERGY SAVING, RINSING, 13.2 Choosing individual functions, 12.1 Interrupting the descaling cycle, 13.1 MENU/OK command

ENGLISH

RINSE MACHINE

OPEN KNOB

10Turn the steam knob (16) anticlockwise to empty out the contents of the water tank

MACHINE IS RINSING

by pressing “MENU/OK” (28) when the machine is in a standby status.

To select the desired function, press the “∧” button to move up one line or the “∨” button to move down on the display.

To exit the programming mode press “ESC”

11 When the machine rinse cycle is completed the display will show:

RINSING FINISHED

CLOSE KNOB

12 Close the tap, reload the circuit and let the machine heat up

If you use a product other than the recommended one, you should follow the manufacturer’s directions on the

package.

13.2 Choosing individual functions

Select the desired function by pressing “∧” or “∨”. Press “MENU/OK” to enable the desired function; you can browse the selectable settings using the “∧” or “∨” button; to store a setting press “MENU/OK”.

Note: by pressing “ESC” you can exit the programming mode at any time without saving the changes made; exiting without saving is possible only before you have pressed

“MENU/OK”.

12.1 Interrupting the descaling cycle

If the descaling cycle is interrupted by switching the machine OFF, it will automatically resume when the

machine is switched back ON.

The descaling cycle can be interrupted by turning the steam knob (16) clockwise and then pressing the button (27).

The display will show:

DESCAL. INTERRUPTED

EMPTY WATERTANK

Warning! After interrupting the cycle you must empty the water tank of the descaling solution and wash out the tank with fresh drinking water; the machine circuit must be

cleansed by carrying out a rinse cycle. The display will show:

RINSE MACHINE

PRESS KEY

Follow the directions for a normal rinse cycle provided in section 8 of the previous chapter.

13 FUNCTION PROGRAMMING

The user can change some machine operating parameters according to personal needs.

13.1 MENU/OK command

In order to program functions you must access the programming mode

13.3Description of programmable functions

ENERGY SAVING

If the appliance is used little, it may be switched to the ENERGY SAVING mode. This function allows electricity costs to be reduced. However, it is recommended to switch the appliance off completely using the on/off switch (7) if it is not to be used for a prolonged period. It will take the machine just a few minutes to heat up when you switch it back on.

• In the programming mode press “∧” or “∨” to select the function:

ENERGY SAVING

and enable it by pressing “MENU/OK”; the following message will appear:

ENERGY SAVING

in this mode the machine remains on but no components are active.

• To deactivate the “ENERGY SAVING” function, press “MENU/OK”.

RINSING

Immediately after heating up, the appliance automatically eliminates the water left standing in the internal circuit to ensure that only fresh water will be used to make coffee.

The function is activated in the factory.

• To deactivate it, go to the programming mode and press “∧” or

• 34 •