GB
8. Troubleshooting / Service
DANGER! Cutting tool can cause injuries!
V When rectifying faults remove the key and wear suitable
| work gloves. |
|
|
Problem | Possible cause | Remedy | |
|
|
| |
Abnormal noise. | Screws / components loose. | v Tighten screws or send | |
Clattering in the mower |
|
| to GARDENA Service. |
|
|
| |
| Foreign bodies on the blade. | v Remove foreign bodies. | |
|
|
| |
| Notch in the blade. | v Remove notches with | |
|
|
| grindstone. |
|
|
| |
| Blades are striking each other | v Adjust cutting mechanism. | |
| too hard. |
|
|
|
|
| |
Motor will not start | Key not inserted. | v Insert the key into the socket. | |
|
|
| |
| Circuit breaker has been | v Wait approx. 5 | |
| triggered (Red |
| then turn on the mower |
| flashes). |
| again. |
|
|
| |
| Tab on Accu loose. | v Open the cover and push | |
|
|
| the tab receptacle onto the |
|
|
| tab. |
|
|
| |
| Full discharge protection | v Charge Accu. | |
| has responded. |
|
|
|
|
|
|
Motor jams and is noisy | Blocked by foreign body. | 1. | Switch off mower, |
| Blocking protection activated. | 2. | Remove key. |
| (Red | 3. | Remove foreign body. |
|
|
| |
| Cutting load too high. | v Reduce mowing speed and / | |
|
|
| or raise cutting height. |
|
|
| |
Motor turns off | The cutting height you have | Let the motor cool for 5 | |
| selected is too low; | utes, then use the mower with | |
| Circuit breaker has been | a higher cutting height and | |
| activated. | reduce the cutting height in | |
| (Red | stages until you reach the lower | |
|
| cutting height you require. | |
|
|
| |
Runs unevenly, mower | Cutting tool damaged. | v Have cutting tool checked | |
vibrates significantly |
|
| by an authorised specialist |
|
|
| dealer or GARDENA- |
|
|
| Service. |
|
|
| |
| Blade very dirty. | v Clean blade. | |
|
|
| |
Lawn cut unevenly | Blade set incorrectly. | v Adjust cutting mechanism. | |
|
|
| |
| Cutting mechanism blunt. | Recommendation: | |
|
| v Have cutting mechanism | |
|
|
| reground or replaced by |
|
|
| GARDENA Service. |
|
|
| |
| Lawn too long. | v See 4. Function “Mowing | |
|
|
| Tips”. |
Readjusting the | The cutting gear of your lawn mower was optimally adjusted be- | ||
cutting mechanism: | fore leaving our company. If, after longer use, a clean cut of the | ||
| grass is no longer possible or the blade roller contacts the lower | ||
| blade, then the lower blade should be adjusted as follows: | ||
18
