4Press the battery into place.
5Replace the battery cover, and turn the
Charging the Handheld Device
NOTICE
To prevent corrosion, thoroughly dry the
You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the temperature range of 32° to 104°F (0° to 40°C).
1 Lift the weather cap .
À
2Plug the small end of the power cable into the
on the device.
Á
3Plug the other end of the power cable into an appropriate power source.
Charging the Dog Collar Device
NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip.
Before you put the collar on the dog, remove the charging clip. If you do not remove the clip, it may become detached from the collar and become lost.
You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about two hours. The device will not charge when outside the temperature range of 32° to 104°F (0° to 40°C).
1 Snap the charging clip onto the device.
À
2Plug the small end of the power cable into the
on the charging clip.
Á
3Plug the other end of the power cable into a power source. The status LED is solid red when the collar is charging.
4After the status LED turns solid green, remove the charging clip from the collar.
Turning On the Devices
•On the handheld device, select the Power key.
•On the collar, select the Power key.
The collar beeps and the status LED blinks green when the collar is turned on.
Turning Off the Devices
•On the handheld device, hold the Power key.
•On the collar, hold the Power key until the status LED turns red, about 3 seconds, and then release the Power key.
Acquiring Satellite Signals
Before you put the collar on your dog, both the collar and handheld device must acquire satellite signals. Acquiring satellites can take a few minutes.
1Go outdoors to an open area.
2 Turn on both devices (page 2). 3 Select the Power key.
The GPS signal strength of the handheld device is listed in the
When the collar has acquired satellite signals, the status LED flashes a
Using the Touchscreen
•Select 
to open the application drawer.
•Select 
to open a menu.
•Select 
to close the page and return to the previous page.
•Select 
to return to the previous page.
•Select 
to save changes and close the page.
•Select 
and 
to scroll.
•Select 
to search by name.
Locking the Touchscreen
You can lock the screen to prevent inadvertent screen touches.
1Select the Power key.
2 Select 
.
Unlocking the Touchscreen
1Select the Power key.
2 Select 
.
2 | Getting Started |