To mount the bracket assembly:

1.Using the tilt mount bracket (Fishfinder 90) or the swivel base (Fishfinder 140; Fishfinder 90 option) as a template, mark the location of the three holes that you use to secure the bracket to the mounting surface.

2.If securing the base with machine bolts, drill three 5/32" holes at the locations you marked; or, if securing the base using self-tapping screws, drill 1/16" starter holes at the locations you marked. Drill starter holes no deeper than half the screw length.

3.Secure the tilt mount bracket or swivel base with three bolts or screws. DO NOT OVERTIGHTEN.

4.If you are using the swivel mount, place the swivel mount bracket over the swivel base and secure it with the short knob.

Swivel mount bracket

Tilt mount bracket

Swivel base

(Fishfinder 140;

(Fishfinder 90)Fishfinder 90 option) Fishfinder 90/140 Owner’s Manual

Installing Your Fishfinder

To install the Fishfinder on the mount bracket:

1.Align the slot on the back of the Fishfinder with the long mounting knob, and slide the Fishfinder into place. If necessary, adjust the long knob to spread the bracket arms apart. (Turn counter-clockwise to widen the bracket arms and clockwise to tighten.)

2.Adjust the Fishfinder angle, and tighten the long mounting knob until snug.

3.For the Fishfinder 140 (Fishfinder 90 option), rotate the swivel mount bracket by twisting it left or right. The bracket clicks as you turn it. Select a good viewing angle, and then tighten all knobs.

11

190-00582-10_0A.indd 11

 

 

12/2/2011 3:08:58 PM