1Sett Up thet Printeri t
1 Unpack the Printer
Remove all the tape and packing material as described on the Unpacking Sheet in the printer box. Make sure you’ve got a cable to connect the printer to your computer, plus all these items:
paper support | color ink |
cartridge |
black ink cartridge
printer software
| Media Pack with samples |
printer | of EPSON® ink jet papers |
|
Printer Basics book
Note:
To connect to a PC, you’ll need a high- speed, bidirectional,
Place the printer near your computer and an available grounded outlet, but avoid areas:
■with high temperature or humidity
■in direct sunlight or dusty conditions
■near sources of heat or electromagnetic interference, such as a cordless telephone base unit
Be sure to check the System Requirements and follow all the Safety Instructions in your Printer Basics book. If you need help as you set up your printer, see “Problems? Need Help?” in your Printer Basics book.
2 Attach the Paper Support
Insert the paper support in the slots at the back of the printer’s sheet feeder.
3 Install the Ink Cartridges
1. Plug the power cord into a grounded outlet.
Caution:
Don’t use an outlet controlled by a wall switch or timer, or one on the same circuit as a large appliance. This may disrupt the power, which can erase the printer’s memory or damage its power supply.
2.Remove the ink cartridges from their foil packages. Then pull off only the yellow part of the tape seal on the top of each cartridge.
Caution:
You must remove the yellow tape seal from the top of the cartridge or you will permanently damage it.
Open to continue
▼