TR-1 Gold Owner’s Handheld Quick Reference
Click 
to go from Standby to Autopilot mode.
To engage GPS push and release [GPS Track] button (Must plot a waypoint, route or steer to cursor).
For Man Overboard Maneuver press and release the [MOB] button. (Williamson Turn)
Idle Resume (Factory Default),
Step Turns, Circles, and Remote Steer to port when NOT in GPS Mode.
Orbit, Clover Leaf and Search to Port when IN GPS Mode.
Press and hold the [SETUP] Button to see what your buttons are set at.
To autopilot in reverse: 1) Start from Standby 2) Press and hold the [GPS REV] button 3) Press and release the [Auto/ Stby] button 4) Release the [GPS REV] button.
Increase throttle by pressing the [Up Arrow] button. Decrease throttle by pressing the [Down Arrow] button. The electric throttle runs in parallel with the tiller throttle, this means that you can’t reduce the RPM with the electric throttle if the tiller throttle is set high. It is best to always run with the tiller throttle set to idle.
Step Turns, Circles and Remote Steer to Starboard when NOT in GPS Mode.
Orbit, Clover Leaf and Search to Starboard when IN GPS Mode.
To change from Idle/Resume to MOB you would: Press and hold [SETUP], then press the [MOB] button twice, you will see the light change from #2 to #1.
Note: Boat Hydraulics too active, but the boat holds course? Try adjusting the Sea State Filter. This is adjustable at four levels,
(4). Press and release the [Setup] button, press the 1,2,3 button once to light up code #1, decrease this function by pressing the down arrow button until the setting is most comfortable for your use. If you wish to save this setting, Press and Hold the [Select Load] button while pressing and releasing the deckmount On/Off switch.
