Gary Fisher Axiom Cycling Computer Clock CLK, Resetting the Computer, Sleep Mode, Installation

Maximum Speed (MXS)

The Maximum Speed reached during a ride is displayed in 0.1 mi/Km incre- ments on the top line, with the MXS icon. Maximum Speed is stored in memory and is updated each time a new, higher speed is reached.

CLOCK (CLK)

The 12 hour clock is displayed on the lower line, indicated by the CLK icon.

ATM “Lap Timer” Display

A unique ATM “Lap Timer” display allows you to lock the display at the end of a ride segment and view the ATM, DST, AVS and MXS at a later time. This is especially useful at the end of a race, allowing you time to cool down without adding time to your Stopwatch.

As you cross the finish line, press the left key for over 1 second to freeze informa- tion on the display. You may continue to ride, viewing the information locked on the flashing locked display. The computer will continue to record information and store it in memory. Press the left key to update the current display information.

RESETTING THE COMPUTER

In SPD/ATM mode, press both keys for over two seconds to clear ATM, DST, AVS and MXS display.

SLEEP MODE

To conserve battery power, the computer will enter the ‘Sleep’ mode after 5 min- utes of no speed input, blanking the dis- play. Press any key to enter normal operating modes.

(Note: Unit will not enter sleep mode in setting function mode.)

INSTALLATION

Axiom and Wheel Magnet

1.Position the axiom unit to the inside of either the right of left fork blade anywhere from 3-6 inches up from the fork blade tip. Attach the axiom to the fork blade with the quick ties but do not tighten the ties completely until final adjustment is complete.

2.Attach the wheel magnet to a spoke, aligning the magnet with the axiom so it faces and intersects the bottom polished line on the axiom. The magnet should have 1-2 mm clearance from the axiom. If the axiom and magnet are too close or touching, rotate the axiom unit toward the back of the fork blade until adequate clearance is achieved. Carefully tighten the quick ties making sure you maintain the proper space between the magnet and the axiom. Trim the excess quick tie strap using a scissors or fingernail clip- per. Tighten the magnet screw, but be careful not to over tighten as this can damage the fitting.

Axiom Wiring and Bracket

1.Route the axiom wire up the back of the fork blade or wind the wire around the blade, making sure that the wire is not loose and that you leave enough wire to reach the handlebar. Secure the wire to the fork blade immediately above the axiom and at the top of the fork blade, using the adhesive strips that are provided or electrical tape.

2.Wind the wire upward around the front brake cable until the wire is adja- cent to the handlebar, allowing enough slack for free movement of the steering assembly cables.

3.Attach the bracket to the handlebar on either side of the stem. The bracket goes onto the handlebar with the wire toward the rider side of the bar. Use the appropriate rubber shim between the bracket and handlebar to provide a secure fit.

Shims will prevent slipping

Attaching the Computer to the Bracket

The Fisher Axiom Computer attaches to the mounting bracket by sliding the unit onto the bracket from the back until it snaps firmly into position. To remove the computer from the bracket, place your thumb against the back of the mounting bracket and pull the computer toward you with your index finger.

4 5