Gary Fisher Cronos manual

1 | pitchbook2010

cronus

2010 service information

Contents

Main Service Information cronus 2010 table of contents Working with Carbon Fiber Parts Keep carbon away from sharp edges or excessive pressure Clean carbon parts before installation Never modify the fork, frame, or components Cutting a carbon ber steerer These instructions explain the best practices for cutting a carbon ber steerer tube. About cutting carbon ber Measure twice, cut once Use the correct tools in the correct manner to cut the steerer Headset Installation special care information Page To install the shims, bearing cover, and spacers inspecting the Headset To check is the headset is too loose To check is the headset is too tight Fender Installation Installing the eyelets Attaching the bridge clips Finishing the installation FCC Steering System Wider hub anges Large-diameter end caps on hub Do not put the FCC front wheel in another bike Crankset Installation sram GXP Page Page shimano Hollowtech Page Page Page campagnolo ultratorque To install the seal seats To install the non-drive side bearings To install the drive side bearings inspecting the bottom bracket fsa megaexo aL Page Page Cronus Crankset Troubleshooting Bearing play in a GXP crank or bottom bracket assembly Wave washer not compressed fully Spline of GXP crankarm is undersized crank is rubbing or there is excessive drag If you notice that the crank arms rotate poorly, there are several possible issues. Out of spec or bent non-drive metal seal Bearing not seated properly GXP triple crankset cant be properly preloaded