GBC 620OS operation manual Shield’s Safety Interlocks

GBC 620os Operation Manual

LOADING FILM & THREADING FILM

Figure5

Figure 6

Figure 7

STEP 5:

•Attach the end of the Threading Card to the activated film. The Top Main Roller must be hot to activate the adhesive to ensure that the Threading Card sticks. (Figure 5).

•Replace the Safety Shield and lock in the Safety

Shield’s Safety Interlocks.

STEP 6:

•While pressing “LOADING”, push another sheet into the nip area under the sheet you just tacked to the film. (Figure 6).

•Continue holding down “LOADING” until the first sheet enters the Burst Rollers while feeding additional sheets.

•Once the first sheet exits the Burst Rollers, release “LOADING”.

STEP 7:

•Verify that the “Threading Card” and images are traveling over the Decurling Bar. (Figure 7). Monitor the amount of curl of the finished laminated images. Adjust the Decurling Bar Knob to increase or decrease the amount of curl desired.

•Press “START”

•When the green LED is illuminated, place another image onto the Feed Belts and guide it into the Feed Gate. The Feed Gate will automatically activate according to sheet size and open, allowing the image to be entered into the nip.

•When the green LED is illuminated, place another image onto the Feed Belts and guide it into the Feed Gate.

STEP 8:

•Set the In-Line Perforator Wheel on the very outer edge of the image but still making contact with the film. Make any adjustments needed to ensure the Perforator Wheel is penetrating the film, leaving small holes in the film. Verify that the gray wheel is off the image. (Figure 8&8A).

Figure 8A

© 2007 General Binding Corporation Page 15