PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety pre- cautions should always be taken including the fol- lowing:
•Use fan only for purposes described in the instruction manual.
•To protect against electrical shock do not immerse unit, plug or cord in water or spray with liquids.
•Close supervision is necessary when any appli- ance is used by or near children.
•Unplug from outlet when not in use, when mov- ing fan from one location to another, before put ting on or taking off parts, and before cleaning.
•Avoid contact with moving parts.
•Do not operate in the presence of explosive and or flammable fumes.
•Do not place fan or any parts near an open flame, cooking or other heating appliance.
•Do not operate any appliance with a damaged cord, plug, after the appliance malfunctions, or has been dropped / damaged in any manner.
•The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
•Do not use outdoors.
•Do not let the cord hang over the edge of a table, counter or come in contact with hot sur- faces.
•To disconnect, grip plug and pull from wall out let. Never yank on cord.
•Always use on a dry, level surface.
•Do not operate without fan grills properly in place.
•This product is intended for household use ONLY and not for commercial or industrial applications.
WARNING: To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN, with any SOLID STATE Fan Speed Control Device.
PLEASE READ AND
SAVE THESE
IMPORTANT SAFETY
INSTRUCTIONS
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current)PLUG (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet. DO NOT DEFEAT THE SAFETY PUR-
POSE OF THIS POLARIZED PLUG IN ANY WAY.
ASSEMBLY INSTRUCTIONS
Base / Pole Assembly
Step 1: Slide the bottom end of the outer pole through the pole ring.
Step 2: Turn the base cover upside down and place the weighted insert and washer into the base cover.
Step 3: Insert the threaded end of the L shaped locking lever into the hole of the washer, weighted insert and through the base cover.
Step 4: While holding the base and weighted insert together, connect the pole to the base, sliding the washer and L shaped locking lever into the bot- tom of the outer pole.
Step 5: Turn the L shaped locking lever clockwise to
securely attach the pole to the base.
Step 6: Set the base on the floor, weight side down. Push the pole ring down until it sits directly on the base.
Fan Head Assembly
Step 1: Position the rear grill over the motor shaft, mak- ing certain the notches at the top and bottom of the rear grill fit over the prongs on the motor housing. Please make sure the rear grill fits securely against the motor housing.
Step 2: Secure the rear grill in its place using the rear grill
Step 3: Slide the fan blade, with the hollowed interior of the blade facing toward the rear grill, firmly onto the motor shaft. The top of the motor shaft should lie even with the center of the fan blade.
