To Mount on a Wall

1.Plug the short line cord into the jack on the bottom of the base and connect the other end to a wall phone jack.

2.Feed the short line cord through the grooves provided so that the base area is flat and ready to mount on the wall.

3.Slip the mounting holes of the base (on bottom of unit) over the wall plate posts and slide the base down until the phone is firmly in place.

4.Plug the coiled cord into the handset. Plug the other end into the jack on the lower end of the base.

5.Set the RINGER switch on the base to HI.

•LO = Sound will be lower.

•OFF = Telephone will not ring.

6.Place the handset in the base.

RINGER VOLUME

HI LO OFF

Image 12

Contents

9190 FCC Registration Information Notification to the Local Telephone Company Interference Information Do not Open Table of Contents Introduction Parts Checklist Before YOU BeginModular Jack Requirements Installation & Setup Important Installation InformationInstalling the Batteries Setting UP the Caller ID Menu Exit Setup To SET Your Local Area Code To SET the CID Display Language To SET the Dial Mode To Exit SetupTo SET the LCD Contrast Installing the Phone To Install on a Desktop To Mount on a Wall Caller ID Features Summary ScreenReceiving and Storing Calls Unlocking the Caller ID Button If YOU Programmed Your Local Area Code in the Setup Menu Reviewing Call RecordsDeleting Call Records Dialing Back Digits Message Indicators Unknown Call Changing the Volume Using ONE Touch RedialTelephone Basics Redialing a Number Using Memory Features To Store EMERGENCY/QUICK Dial NumbersTo Store Frequently Called Numbers To Change a Stored Number To Erase a Stored Number To USE Pause RedialTo USE Flash To USE Temporary Tone Dialing Troubleshooting Tips Service Incoming and Outgoingvoice Volume LOWTone Feedback Flutter When Dialing in Pulse Mode Index Page Limited Warranty What we will do

GE 15381860 manual To Mount on a Wall