GE 15381860 Installation & Setup, Important Installation Information, Installing the Batteries

INSTALLATION & SETUP

IMPORTANT INSTALLATION

INFORMATION

•Never install telephone wiring during a lightning storm.

•Never touch uninsulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface.

•Use caution when installing or modifying telephone lines.

INSTALLING THE BATTERIES

Your Caller ID phone uses 4 AA-size alkaline batteries for receiving and storing Caller ID records and for the numbers you use for memory dialing.

IMPORTANT: You will have approximately 60 seconds to replace the batteries before the memories stored in the handset are lost. Please read the instructions before replacing the batteries and have the batteries ready to be inserted beforehand.

1.If both the straight and coiled line cords are already connected, disconnect them from the base unit. Place the handset off to the side.

2.Use a screwdriver to loosen the two screws on the battery doors located on the bottom of the base. Once the screws are fully loosened, (they will not come all the way out), slide the doors in the direction of the arrows.

3.Insert 4 AA-size alkaline batteries as shown on the diagram in the battery compartments. Two batteries will be inserted for each compartment.

4.Replace the battery compartment doors securely and tighten the screws, being careful not to strip the threads.

5.If the cords were previously connected, re-attach the line cords to the unit and check your memory locations.

7