GE 200D8074P039 About the temperature controls, About TurboCool. on some models, Consumer Support

Operating Instructions Safety Instructions

Installation Instructions

About the temperature controls.

Not all features are on all models.

The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.

The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and freezer. The actual temperature may vary slightly from the SET temperature based on usage and operating environment.

On some models, setting both controls to the warmest setting until the display flashes (off) will stop cooling in both the freezer and refrigerator compartments.

On other models, setting either control to the warmest setting until the display flashes (off) will stop the cooling to the freezer and refrigerator.

NOTE: Turning the refrigerator off via the controls on the touch panel does not shut off electrical power

to the refrigerator.

NOTE: The refrigerator is shipped with protective film covering the temperature controls. If this film was not removed during installation, remove it now.

Performance Air Flow System

Troubleshooting Tips

The Performance Air-Flow System is designed to maximize temperature control in the refrigerator and freezer compartments. This unique special feature consists of the Air Tower along the back wall of the refrigerator and the Air Tunnel on the bottom portion of the freezer rear wall. Placing food in front of the louvers on these components

About TurboCool.™ (on some models)

will not affect performance. Although the Air Tower and the Air Tunnel can be removed, doing so will affect temperature performance. (For removal instructions, on-line, contact us at ge.com or

call 800.GE.CARES. In Canada, contact us at geappliances.ca or call 1.800.561.3344.)

Consumer Support

How it Works

TurboCool rapidly cools the refrigerator compartment in order to more quickly cool foods. Use TurboCool when adding a large amount

of food to the refrigerator compartment, putting away foods after they have been sitting out at room temperature or when putting away warm leftovers. It can also be used if the refrigerator has been without power for an extended period.

	Once activated, the compressor will turn on
	immediately and the fans will cycle on and
	off at high speed as needed for eight hours.
	The compressor will continue to run until the
	refrigerator compartment cools to approximately
	34°F (1°C), then it will cycle on and off to maintain
	this setting. After 8 hours, or if TurboCool is
	pressed again, the refrigerator compartment
4	will return to the original setting.

How to Use

Press TurboCool. The TurboCool temperature display will show Tc and the LED will be activated.

After TurboCool is complete, the TurboCool indicator light will go out.

NOTES: The refrigerator temperature cannot be changed during TurboCool.

The freezer temperature is not affected during TurboCool.

When opening the refrigerator door during TurboCool, the fans will continue to run if they have cycled on.