Installation Instructions
STEP 16 DISHWASHER WET TEST
Turn on power supply(or plug power cord into outlet, if equipped).
Select ″Normal wash″program.
Close the door.
Check to be sure that water enters the dishwasher.If water does not enter the dishwasher,check to be sure that water and power are turn on.
Check for leaks under the dishwasher.If a leak is found,turn power supply off,then tighten connections.Restore power afterleak is corrected.
Check for leaks.around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dishwasher if necessary.See step 9.
The dishwasher will drain and turn off about 5 to 7 minutes after the first fill.Check dain lines.If leaks are found,turn power off at the breaker and correct plumbing as necessary.Restore power ater corrections are made.See Step 12.
Open dishwasher door and make sure most of the water has drained.If not ,check that disposer plug has been removed and/or air gap is not plugged.See Step 13.Also chek drain line for kinking.
Run the dishwasher through another fill and drain cycle .Check for leaks and correct if require. 
At the end of drain, Press reset button.
STEP 17 REPLACE TOEKICK
2-Screws
2-ScrewsAdjust Up
or Down 
·Install 2 toekick screws to fasten toekick. Allow the toe kick to tuch the floor.
STEP 18 LITERATURE
Be sure to leave complete literature package and installation instructions with consumer.
NOTE:The manufacturer,following a policy of constant development and
12
