GE 24958 instruction manual IR Transmitter Finder

IR Transmitter Finder

This feature assists you in identifying where your original remotes IR transmitter is located and

is particularly useful if your original remote’s IR transmitter is hidden behind a lens.

1.Point both remotes facing each other by approximately 1 inch apart (see Tips on Learning on previous pages).

2.Press and hold the SETUP button until the red indicator turns on, then release the button.

3.Press and release the desired Mode button (TV, DVD, etc.), the red indicator blinks then stays on.

4.Press and release the LEARN button, the red indicator blinks then stays on.

5.Press and hold any Original Remote button and move the Original Remote to the left and right, and/or, up and down in front of the Learning remote IR transmitter. The red indicator will remain on if no IR from the Original remote is found and the red indicator will blink on and off more rapidly when the IR transmitters are lining up. The point where the red indicator blinks most rapidly is where the two IR transmitters are aligned. Note some original remotes will only transmit IR on the initial button press then stop. In these cases, quickly press and release the original remote button repeatedly during this procedure.

6.You can now learn a button from your original remote by continuing from “Step 4” in the “Learning Commands” section on the next page, or, to exit at this point, press and release the SETUP button

14