Programming the Telephone
Registration (only applicable to handset)
A cordless handset will not operate until it is registered to the base. During the registration process, keep the handset near the base. Up to 10 cordless handsets can be registered to one base.
NOTE: If a handset has not been registered to the base, then the screen displays “PRESS “REG” TO INITIATE REGISTRATION” once the handset has been activated. Press the REG soft key to start the registration.
From the Phone Setting Menu:
1.Press the VOL (+ or
2.Press SELECT soft key and you may program the following items: Register and Remove handset.
Register
From the Phone Setting Menu:
1.Press the VOL (+ or
2.Press SELECT soft key. The screen displays “Press base unit Page button until beep”.
3.Press and hold the Page button on base for 5 seconds.
4.“Registration” displays to indicate the base is now in registration mode.
5.If the registration is successful, the screen displays “Registration complete” for 2 seconds and emits a confirmation tone.
6.If the registration is failed (i.e. timeout), the screen displays “REGISTRATION FAILED!” for 2 seconds and emits an error tone.
Remove Handset
WARNING: It is not recommended that a handset be deregistered unless absolutely necessary because once a handset is deregistered, that handset’s telephone features cannot be used until the handset is
From the Phone Setting Menu:
1.Press the VOL (+ or -) button to scroll to the Remove handset.
2.Press SELECT soft key button. The screen displays “Remove handset?”.
3.Press the YES soft key to confirm
NOTE: You can press the REG soft key to enter the registation mode again.
17
