
• The wireless monitor receives data from the generator | NOTICE None of the conditions on the display unit can be | ||
every 10 minutes and displays the generator status | |||
cleared at the wireless monitor. All alerts must be cleared at | |||
through 3 LED’s. |
| ||
| the generator control panel. | ||
|
| ||
• Pressing the sySTEM updATE button will provide | NOTICE Service conditions will only be displayed on the | ||
current generator status by flashing the status LED’s. | |||
basic monitor when the control board is placed in AUTO | |||
When pressed, all 3 LEDs will flash until the generator | |||
mode. | |||
status is received. |
| ||
| Other: | ||
NOTICE Generator control panel must be in AUTO mode or | |||
| |||
no communication with monitor will occur. |
| LED Lighting Codes | |
• In order to conserve power and to extend battery life, | • Batteries Inserted - GenerATOR ReADY LED will light | ||
the LED’s are not lit continuously; instead they are | for 5 seconds. | ||
briefly flashed as indicated below. |
| • Wireless Communication Lost - Service Needed LED | |
|
| ||
NOTICE During the weekly exercise cycle, the generator will | will flash 20 fast pulses, then pause for 5 seconds, | ||
run for 20 minutes, but it will not supply power to the home. | and repeat the sequence until the communication | ||
During the exercise cycle, the monitor will continue blinking | has been restored. | ||
the GENERATOR READY green LED. |
| NOTICE Communication lost issues can typically be resolved | |
|
| ||
• GENERATOR READY - When active, the green LED will | by moving the wireless monitor closer, within the home, to | ||
flash once every 7 seconds. The green LED indicates | the standby generator. | ||
that the generator is in AUTO mode and that it is | • Linking Error or ot Linked - Service Needed LED will | ||
ready to run in the event of a loss of utility power. | |||
light for 4 seconds, pause for 4 seconds, and repeat | |||
|
| ||
• GENERATOR POWER - When active, the green LED will | the sequence until a successful link is completed. | ||
flash every 7 seconds. The green LED indicates that |
| ||
the generator is supplying power. |
|
| |
• SERVICE NEEDED - When active, the red LED will flash |
| ||
in a sequence that corresponds to the service code. |
| ||
For example, when Low Frequency scrolls across the |
| ||
control board, the red LED will flash 5 times with a 3 |
| ||
second pause between series of blinks until it is reset |
| ||
or the condition is corrected. When the ed LED is lit, |
| ||
NOT |
|
| |
for |
| ||
| REPRODUCTION |
contact your nearest authorized service dealer.
Installation Inspection
Before placing the generator system into service, inspect the entire installation carefully, utilizing the Installation Checklist on page 9.
This completes the installation and
Maintenance and Troubleshooting for this generator system.
39