Antenna Placement
The wireless monitor includes an antenna that was installed at the factory.
Before shipping, the magnetic-backed antenna was moved to the side of the generator to prevent damage (A)A.
Before starting the wireless monitor, mount the antenna on the top of the unit (B).
A

B

Wireless Monitor Operation

vice needed

3 under/over voltage 7 high temperature

4 engine does not start 8 transfer switch

part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C

1. Remove battery access cover (C)C on back of monitor

tem update

 

and install 2 AA batteries. (Observe correct battery

 

 

polarity which is embossed in the bottom of the

 

 

NOT 2. The wireless monitor does not haveforan on/off

battery compartment). Replace battery accessREPRODUCTIONcover.

switch. When batteries are installed c ectly, the GENERATOR READY green LED light will flash once every 7 seconds indicating the status of the

generator.

DEALER NAME

C

 

 

 

NOTICE If communication does not begin upon placing the

DEALER PH E

 

 

 

generator in AUTO, installing batteries, and pressing System

 

 

Update, the monitor may need to be re-linked. To link, follow

 

 

Steps 3 through 6.

 

 

NOTICE The wireless monitor was linked to the generator at the factory. Communication will begin upon the installation of the batteries and the generator being placed in AUTO mode. You may need to press System Update one time.

37