Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
door must be closed and locked into place to select a LOAD SELECTIONor an OPTION.
Ifthe door is openedduring a cgcleand left open,the dishwasherwill beep once every30 secondsuntil the door is cosed and arched into p ace.
Start
Close and latch the doon Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your last cgcle so you don'thave to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and displag the last settings you selected.
If you don'twant to change ang of the settings, simply touch the START/RESETpad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATEDDRY will automatically be programmed. Hake any new selections and touch the START/RESETpad to begin the cycle.
Clean
This light is illuminated when a wash cgcle is complete. The light will stag ON until the door is opened.
Flashing Displag Lights
Lights | What It Means | What | To Do |
| This is normal. | Allow | the dishwasher to drain and reset before you start a new |
| The START/RESET pad | wash | cycle. |
| has been pressed. |
|
|
Control Error
CLEAN
PL US A
BEEPING
SOUND
Control Error
a
Asj
PLUS A
BEEPING
SOUND
Pressthe START/RESETpad to turn off the beeper If the CLEAN light continues to flash, call for service.
Pressthe START/RESETpod to turn off the beeper and the dishwasher will attempt to reset. Restartthe wash cgcle.
If this error continues,turn off the power to the dishwasher at the circuit breaker for 30 seconds. Try the dishwasher again. If the error is still present, call for service.
8