Window Installation Instructions
7INSTALL THE CASE IN THE WINDOW
AOpen the window and mark the centerline of the window stool.
BCarefully place the case on the window stool and align the center mark on the bottom front with the centerline of the stool.
CPull the window down behind the top mounting rail.
NOTE: Do not shut the window so tightly that movement of the accordion panels is restricted.
DSelect the position that will place the sill supports near the outermost point on the sill. Place the short side of the sill supports, on the case bottom, toward the window. Attach the sill supports to the case track hole in relation to the selected position using 2 Type B screws in each support.
CAUTION: Do not install this air conditioner in a window if the bolts do not contact the window sill.
Long side of sill supports
OUTSIDE
EAdjust the bolt and the nut in each support so that the case is installed with a slight tilt to the outside. Use a level; no more than 1/2 bubble will be the correct case slant to the outside.
7INSTALL THE CASE IN THE WINDOW (CONT.)
FSecure the case to the window stool by using 3 Type D screws.
Sill support
GPull the accordion panels to each window sash track. Attach them on each side to the window sash and the window stool using 4 Type C screws.
8SECURE THE CASE IN THE WINDOW AND INSTALL THE FOAM TOP WINDOW GASKET
A Attach the window locking brackets (one on each side) with Type C screws.
BCut the foam top window gasket to the window width.
C Stuff the foam between the glass and the window to prevent air and insects from getting into the room.
10
