About the controls on the air conditioner—models with control knobs.
Features and appearance will vary.
The air conditioner controls are located behind the control panel
door. Press to open and close the door.

Mode Control

High Cool, Med Cool and Low Cool provide cooling with different
fan speeds.
Fan settings provide air circulation and filtering without cooling.
NOTE: If you move the mode control from a cool setting to OFFor to a fan
setting, wait at least 3 minutes before switching back to a cool setting.
Cooling Descriptions
For Normal Cooling—Select High Cool or Med Cool with the
TEMPERATURE control at midpoint.
For Maximum Cooling—Select High Cool with the TEMPERATURE
control at the highest number available on your knob.
For Quieter & Nighttime Cooling—Select Low Cool with the
TEMPERATURE control at midpoint.

TEMP Control

The TEMP control is used to maintain the room temperature.
The compressor will cycle on and off to keep the room at the
same level of comfort. When you turn the knob to a higher
number, the indoor air will become cooler. Turn the knob to a
lower number and the indoor air will become warmer.

CIRCULAIRE

For continuous side-to-side air circulation, set the Circulaire
switch to ON.
For fixed side-to-side air direction, set the Circulaire switch to ON
until the desired air direction is obtained, then move it to OFF.

TEMPERATURE

CONTROL
(on some models)
MODE
Low
Cool
High
Cool
OFF High
Fan
Low
Fan
Med
Cool
7
Coolest
6
5
4
3
2
1
TEMP
Safety Instructions
Operating
Instructions
Care and Cleaning
Installation
Instructions
Troubleshooting TipsConsumer Support

MODE

CONTROL
(on some models)

MODE

CONTROL
(on some models)

TEMPERATURE

CONTROL
(on some models)
Controls

Temp Control

The temp control is used to maintain the room temperature.
The compressor will cycle on and off to keep the room at the
same level of comfort. Turn the knob clockwise to Cooler(blue)
and indoor air will become cooler. Turn knob counterclockwise
to Warmer (red) and the indoor air will become warmer.

Mode Control

Hi Cool and Low Cool provide cooling with different fan speeds.
Hi Heat and Low Heat provide heating with different fan speeds.
Fan Only setting provides air circulation and filtering without
cooling or heating.
NOTE: If you move the mode control from a cool setting to Off, a fan
setting or a heat setting, wait at least 3 minutes before switching back to a
cool setting.

Cooling Descriptions

For Normal Cooling—Select Hi Cool or Low Cool with the temp
control at midpoint.
For Maximum Cooling—Select Hi Cool with the temp control
turned clockwise as far as possible.
For Quieter & Nighttime Cooling—Select Low Cool with the temp
control at midpoint.

Heating Descriptions

For Normal Heating—Select Hi Heat or Low Heat with the temp
control at midpoint.
For Maximum Heating—Select Hi Heat with the temp control
turned counterclockwise as far as possible.
For Quieter & Nighttime Heating—Select Low Heat with the temp
control at midpoint.

Circulaire

For continuous side-to-side air circulation, set the Circulaire
switch to On.
For fixed side-to-side air direction, set the Circulaire switch to On
until the desired air direction is obtained, then move it to Off.