GE AES15 Window Mounting, Window Requirement, Remove the Chassis, Assemble Window Hller Wneh

Window Mounting

Window Requirement

(continued)

A 112” clearance below the window stool is required.

If the storm window frame does not allow this clearance, attach a 1 Y2 ~ or 2~wide strip of wood along the entire length of the window opening, flush with the back side of the stool, or remove the storm window for the air conditioning season.

1 12”	11 Iizff	201/2”
min.

~ -!min”k ‘~’

; ‘! ./

T

\

stool

Storm Window Frame or Other Obstruction

PI

1. Remove the Chassis.

2.Instill Top Angle and Side Retainers.

				‘1
1. Attach foam gasket ‘
				I
to top angle as shown. ‘-~ . . . .
		x.		2. Install top rail and side retainers
		4
				to cabinet as shown, using 10 Type
	o
				F screws.
			E
		~,
				Window Filler
			,!	Panel

,

,,, 1 m’

Top View

r

Slide chassis from cabinet by holding with left hand while-pulling on handle at bottom front of unit. Be careful of sharp edges on the coil fins.

If your unit has corrugated packing material inside the cabinet, it must be removed. Do not remove the foam pads inside the cabinet.

Note: Handle is N~ intended for lifting the unit. It is only for sliding the chassis out of the cabinet for cleaning or maintenance.

3.Assemble Window Hller Wneh.

1.Place cabinet on floor, bench or table.

2.Slide the “I” section of the window filler panel into the panel retainer on the side of the cabinet as shown above. Do both sides,

3.Insert top and bottom legs of the window filler panel frame into the channel in the top support angle and bottom rail. Do both sides.

. . . . . . . . . .

Air:,,y:g,n~~,, >:1:%:

Y\)1/’ ~ ‘<

,’ Locking

~;,.~:] ~

~ Screw

/Hole

“l” Section ‘---- ‘“

Window

Filler

Panel

4.Insert two Type A screws into holes in the top leg of the filler panel frame. Do not tighten—legs should slide easily.

9