GEAppliances.com
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Power Outage Recovery Feature
In the case of a power outage or interruption, the | will reset to the original setting. You may need to set |
unit will automatically | a new time if desired. |
used after the power is restored. The TIMER feature |
|
Safety Instructions
COOL Mode
Use the COOL mode with HIGH (F3), MED (F2) or LOW (F1) fan for cooling. Use the INCREASE ▲ / DECREASE ▼ pads to set the desired temperature between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
temperature.
For Maximum
For Quieter & Nighttime
temperature.
NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting.
Operating Instructions Installation
FAN Mode
Use the FAN at HIGH (F3), MED (F2) or LOW (F1) to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Vent Control
The vent control is located on the inside of the air | To open the vent, pull the lever toward you. |
louvers on the lower right side. | To close it, push it in. |
When set at CLOSE, only the air inside the room will |
|
be circulated and conditioned. When set at OPEN, |
|
some inside air is exhausted outside. |
|
Air Direction—Up and Down
Fingertip pressure on the bank of horizontal louvers adjusts the air direction up or down.
5
Instructions Troubleshooting Tips Consumer Support
