GE AGV06 Support Troubleshooting Tips Installation, Air Conditioner Controls, Consumer, Mode

Instructions Operating Instructions Safety Instructions

About the controls on the air conditioner—models with touch pads.

Features and appearance will vary.

Energy

Saver on

Fan on

Cool on

Timer on

Air Conditioner Controls Remote Control

Controls

Support Troubleshooting Tips Installation

ON/OFF Pad

Turns air conditioner on and off.

Display

Shows the set temperature or time remaining on timer.

MODE

Use to set the air conditioner to COOL or FAN mode.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode.

FAN Pad

Use to set the fan speed to LOW (F1), MED (F2) or HIGH (F3).

ENERGY SAVER (on some models)—Controls the fan.

ON—The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. NOTE: The fan will continue to run for a short time after the compressor cycles off.

OFF—The fan runs all the time, while the compressor cycles on and off.

This feature must be set at OFF in order to use the fan settings (on the mode control).

TIMER Pad

ON—When the air conditioner is off, it can be set to automatically come on in 1 to 12 hours or 1 to 24 hours (depending on model) at its previous setting. Each touch will set the timer in hours.

OFF—When the air conditioner is on, it can be set to automatically turn off in 1 to 12 hours or 1 to 24 hours (depending on model). Each touch will set the timer in hours.

To cancel the timer, press the TIMER pad until the display time disappears.

Remote Control Signal Receiver

Consumer

Remote Control

■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

■The remote control signal has a range of up to 21 feet.

4

■Make sure nothing is between the air conditioner and the remote control that could block the signal.

■Make sure batteries are fresh and installed correctly as indicated on the remote control.