GEAppliances.com
Do Not Operate in Freezing Outdoor Conditions
This
Remote Control
To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
The remote control signal has a range of up to 20 feet.
Make sure nothing is between the air conditioner and the remote control that could block the signal.
Make sure battery is fresh and installed correctly as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, Med, High or Auto Speed for cooling. Use the Temperature Increase ▲
/Decrease ▼ pads to set the desired temperature between 61°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately
3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling³Select the Cool mode and High or Med fan with a middle set temperature.
For Maximum Cooling³Select the Cool mode and High fan with a lower set temperature.
For Quieter and Nighttime Cooling³Select the Cool mode and Low fan with a middle set temperature.
Energy Saver Mode
Controls the fan. |
|
ON³The fan will cycle on and off with the | OFF³The fan runs all the time, while the compressor |
compressor. This results in wider variations of room | cycles on and off. |
temperature and humidity. Normally used when the |
|
room is unoccupied. NOTE: The fan may continue to |
|
run for a short time after the compressor cycles off. |
|
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed to provide air circulation and filtering without cooling. Since
in the display.
Auto Mode
Set to Auto for the fan speed to automatically set to the speed needed to provide optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed will automatically increase. If the room needs less cooling, the fan speed will automatically decrease.
5
