GE ASP05, AST06 Installation, Instructions Operating Instructions Safety, Finish the Wall Opening

Instructions

Through the Wall Installation Instructions–Optional.

The case may be installed through the wall in both existing and new construction.

Read completely, then follow step-by-step.

Instructions Operating Instructions Safety

1 IMPORTANT

Through the wall installation is not appropriate if any of the side louvers in the case will be obstructed by the wall.

All side louvers in the case must project on the outdoor side of the wall.

The room side of the case must project into the room at least 13⁄4″ from the finished wall.

The case must be installed level from side-to-side and with a slight tilt from front to rear. Use a level; about a 1/2 bubble will be the correct case slant to the outside.

ARemove the air conditioner from the case. For specific instruction, refer to the Window Installation Instructions.

BMake certain a wall receptacle is available close to the hole location or make arrangements to install a receptacle.

CPlace the case in the wall opening and secure with 12 1″ long #10 wood screws.

NOTE: Drill pilot holes, if necessary, for proper installation. If the frame is oversized, use shims to prevent case distortion.

Installation

2	Finish the Wall Opening
	Caulk all four sides on the outdoor side of the case to prevent moisture from getting through to the
	interior wall. Use of flashing (drip rail) will further prevent water from dripping inside the wall and
	down the outside of the building.

Consumer Support Troubleshooting Tips

Lintel angle (if required)

Caulking

OUTSIDE

Air louvers (must project on the outdoor side of the wall.)

Wood Filler and Caulking

(above & below the flashing)

Flashing (Drip rail)

Plaster line

Trim molding (if desired)

INSIDE

Bottom rail

4.5 cm (13/4″) min.

12