GE 49-7400 Safety, Tips Consumer Support, Instructions Troubleshooting, Instructions Installation

www.GEAppliances.com

Additional controls and important information.

Safety

Energy Saver (on some models)

The energy saver switch controls the fan.

ON —The fan and compressor cycle on and off together. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied.

OFF — The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

Instructions Operating

Vent Control (on some models)

The vent control is located on the inside of the air louvers in the lower right corner.

When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

To open the vent, push the lever to the right.

To close it, push it to the left.

Instructions Installation

Air Direction – Side-to-Side

On some models, the side-to-side air direction is adjusted by the louver levers or by grasping and moving the inner vertical louvers.

OR

CIRCULAIRE (on some models)

For fixed side-to-side air direction, set the Circulaire switch to ON until the desired air direction is obtained, then move it to OFF.

For continuous side-to-side air circulation, set the Circulaire switch to ON and leave it there.

Instructions Troubleshooting

Air Direction – Up and Down (on some models)

Fingertip pressure on the horizontal louvers adjusts the air direction up or down.

OR

7

Tips Consumer Support