1. Run wiring from approved wall switches carrying | SECTION 6 |
| |||
the appropriate rating. One neutral (white), one | Completing the Installation |
| |||
ground (green or bare copper), and three hot (black, | 1. Insert the plug from the heating unit into the |
| |||
red, blue leads connected to the switch, one for |
| ||||
each function). Secure the electrical wires to the | receptacle marked “HEAT”, and the plug from the | ||||
housing with an approved electrical connector. Make | fan into the receptacle marked “VENT”(Figure 11). | ||||
sure you leave enough wiring in the box to make the |
|
| |||
connection to the fan’s receptacles. |
|
| |||
2. Connect the white wire from the house to the three |
|
| |||
white wires from the fan. Connect one hot (black) |
|
| |||
wire from the wall switch to the black wire from the |
|
| |||
fan (this is the fan control). Connect second hot (red) | Heater |
| |||
wire from the wall switch to the red wire from the |
| ||||
|
| ||||
fan (this is the heat control). Connect the third hot |
|
| |||
(blue) wire from the wall switch to the blue wire from | Vent |
| |||
the fan (this is the light control). Connect the ground |
| ||||
wire from the house to the green wire from the fan |
|
| |||
(Figure 9). Use approved methods for all connections. |
|
| |||
|
|
| Figure 11 |
| |
|
|
| 2. Remove grill from carton and open light lens area | ||
| Hot (Blue) | by pushing in on the two tabs of the light lens and | |||
| pulling outward from lens. The lens will swing open | ||||
|
|
| |||
|
|
| on the connector bars. DO NOT remove the lens |
| |
|
|
| from the grill (Figure 12). |
| |
|
| Ground |
|
| |
| (Black)Hot | White | Connector Bar |
| |
| Hot (Red) |
|
| ||
|
|
|
| ||
|
|
| Tabs |
| |
Figure 9 |
| Supply from house | Figure 12 |
| |
| 3. Install light reflector into grill by lining up the posts on | ||||
3. Reinstall the wire compartment cover by sliding the | |||||
grill with the holes in light reflector (Figure 13). Raise | |||||
tabs at the bottom of the cover into the slots in the | light reflector and grill up to housing and insert plug | ||||
housing. Make sure all wires are tucked inside of the | from light into receptacle marked “LIGHT” (Figure 11). | ||||
compartment and are not being pinched or showing |
|
| |||
through. Reinstall the two screws removed in Step 3 |
|
| |||
of SECTION 1 Preparing the Unit (Figure 10). | Post |
| |||
|
|
|
| ||
|
| Light | Hole |
| |
| Slot |
| Post |
| |
|
|
|
| ||
|
| Tab |
|
| |
Figure 10 |
| Figure 13 |
| ||
210572111 Rev. B |
| www.geelectrical.com | 4 of 8 | ||
|
|
|