Manuals / Brands / Kitchen Appliance / Range / GE / Kitchen Appliance / Range

GE Coil Top, Radiant Top installation instructions WARNING:

1 44

Download 44 pages, 1.36 Mb

32

Operating

Instructions Safety InstructionsCare and Cleaning

Installation

Instructions

Troubleshooting Tips

Consumer Support

3-Wire Conduit Installation

Remove the 3 screws from the connector block.

Insert bare wires between the connector block

terminals and movable nuts. Tighten screws

securely. Do not remove ground strap connection.

WARNING:

Connector block is approved for

copper wire connection only. If aluminum wire

is used, see note below.

NOTE: ALUMINUM WIRING

A. Do not connect aluminum wire to the connector

block.

Use copper building wire rated for the correct

amperage and voltage to make three 3″copper

jumper wires. Connect wire as per Step 6 or 7

depending on number of wires.

B. Splice copper wires to aluminum wiring using

special connector terminals designed and

UL-approved for joining copper to aluminum

and follow the connector manufacturer’s

recommended procedure closely.

Wire used, location and enclosure of splices, etc., must

conform to good wiring practices and local codes.

4-Wire Power Cord Installation

WARNING:

The neutral wire of

the supply circuit is connected to the neutral

terminal located in the center of the connector

block. The power leads must be connected to

the outside (brass-colored) terminals. The 4th

grounding lead must be connected to the

frame of the range with the grounding plate

and grounding screw.

A. Remove the 3 screws from the connector block.

B. Remove the grounding screw and strap from the

connector block middle location and the screw

connection to the frame of the range.

C. Insert screws through each power cord terminal

ring and into connector block until screw

engages nut. Be certain that the center wire is

connected to the center screw of the connector

block. Tighten screws securely.

D. Attach ground wire to the frame of the range.

Before

After

Neutral terminal

Ground Strap

(grounding to range)

Grounding to range

Grounding

plate

Neutral terminal

Bare wire tips

Conduit

Connector block

Bracket

Screw

Flexible cable

Bare wire

Movable nut

Connector block

terminal

Read these instructions completely and carefully.

Installation Instructions.

Contents

Main Coil Top and Radiant Top Models Ranges 183D6379P010 49-88003 04-01 JR www.GEAppliances.com WARNING ANTI-TIP DEVICE IMPORTANT: IMPORTANT SAFETY NOTICE CAUTION: SAFETY PRECAUTIONS REMEMBER: OVEN SELF-CLEANING OVEN SURFACE UNITSALL MODELS RADIANT SURFACE UNITS NOTE: COIL SURFACE UNITS OFF Cleaning the glass cooktop Using the surface units. Throughout this manual, features and appearance may vary from your model. How to Set Using the radiant surface units. About the radiant surface units Temperature Limiter Selecting types of cookware. Surface Cookware Tips Stainless Steel: Aluminum: heavy weight recommended Using the oven controls. Using the oven controls. OVEN ON Light CLEAN Light PREHEATED Light Oven Temperature Knob Page For ovens without a preheat indicator light or tone, preheat 10 minutes. Broiling guide. BROIL. NOTE: To reduce smoking, do not use the CircuWave fan during broiling. Preheating and Pan Placement Aluminum Foil How to Set the Oven for Broiling Using the oven. Broiling Guide Using CircuWave . Using the clock and timer. To Set the Clock End of Cycle Tones To Set the Timer To Reset the Timer Using the timed baking and roasting features. How to Set an Immediate Start and Automatic Stop How to Set a Delay Start and Automatic Stop Using the Sabbath Feature. (Designed for use on the Jewish Sabbath and Holidays.) How to Set for Regular Baking/Roasting How to Set for Timed Baking/Roasting - Immediate Start and Automatic Stop How to Exit the Sabbath Feature Adjust the oven thermostatEasy to do yourself! HOUR +/ OFF decrease increase Using the self-cleaning oven. CLEAN. CLEAN OFF START TIME ON/OFF Lift-Off Oven Door Be sure electrical power is off and all surfaces are cool before cleaning any part of the range. Oven Interior Page Page Porcelain Enamel Cooktop Do not use abrasives of any kind on the control panel. Painted Surfaces Control Panel and Knobs Stainless Steel Surfaces Never cover the opening with aluminum foil or any other material. Glass Window Cleaning the glass cooktop. Burned-On Residue Heavy, Burned-On Residue Normal Daily Use Cleaning ONLY Damage from Sugary Spills and Melted Plastic BEFORE YOU BEGIN TOOLS YOU WILL NEED ELECTRICAL REQUIREMENTS Page Page 3-Wire Power Cord Installation WARNING: DO NOT remove ground strap connection. Power Cord Strain Relief Installation 3-Wire Conduit Installation Read these instructions completely and carefully. WARNING: Before Page Final Check Read these instructions completely and carefully. Anti-Tip Device Installation Anti-Tip bracket Safety Instructions Page Page Page Page Page Page General Electric Company Warranty Registration Department P.O. Box 32150 Louisville, KY 40232-2150 GE Service Protection Plus Please place in envelope and mail to: Consumer Product Ownership Registration GE Electric Range Warranty. What GE Will Not Cover: Warrantor: General Electric Company. Louisville, KY 40225 For The Period Of: GE Will Provide: All warranty service provided by our Factory Service Centers, or an authorized Customer Care Consumer Support. GE Appliances Website Schedule Service Register Your Appliance Contact Us Parts and Accessories