WSLP1100A/DSKS333EC
GE Spacemaker® Portable Washer and Stationary Dryer with Stack Rack DSR24RW
Dimensions and Installation Information (in inches)
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on |
a label on the dryer back. |
• The dryer MUST be exhausted to the outside. |
Washer Note: Washer wall outlet must be located within 36" of service cord entry. Wall outlet must not be located behind dryer.
Dryer Note: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted in position.
• Minimum clearances between dryer cabinet and adjacent walls or other |
surfaces are: |
0" either side |
3" front and rear |
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”. |
• Closet doors must be louvered or otherwise ventilated and must contain a |
minimum of 60 sq. in. of open area equally distributed. If this closet contains |
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open |
area equally distributed. |
• No other |
a gas dryer. |
Top 
Vent
20
22-7/8
DSKS433EB and
DSKS333EC
Dryer
5
33-1/4
Bathroom or Bedroom Installation:
•The dryer MUST be exhausted to the outdoors.
•The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.
Minimum Clearances other than Alcove or Closet Installation:
•Minimum clearances to combustible surfaces
0" both sides 3" rear
38" | WSLP1500J |
WSLP1500J | Portable |
Portable | Washer |
or | or |
WSLS1500J | |
Stationary | |
WSLS1500J | Washer |
Stationary |
|
Stack Rack
DSDR24D
46
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.
|
Listed by
Underwriters
Laboratories
Specification Revised 5/09 | 360428 |
