GE Free-Standing Electric Ranges warranty Install the Range, Replace the Wire Cover

Installation Instructions

INSTALL THE RANGE

8 REPLACE THE WIRE COVER

Replace the wire cover on the range back by sliding its left edge under the retaining tabs and replacing the five screws removed earlier. Make sure that no wires are pinched between the cover and the range back.

5 screws to replace wire cover

Retaining tabs

Back of	Wire
range
	cover

9 ANTI-TIP DEVICE INSTALLATION

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall

WARNING:

•Range must be secured by Anti-Tip bracket supplied.

•If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

•See instructions to install (supplied with bracket).

•Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may result from spilled hot liquids or from the range itself.

10PREPARE TO LEVEL MODELS WITH BAKING OR WARMING DRAWERS

AMeasure the height of your countertop at the rear of the opening (X).

X

Y

BAdjust two rear leveling legs so that the rear of the cooktop is at the same height as the counter (Y).

CSlide unit into place.

11REMOVE STORAGE DRAWER ON MODELS WITHOUT BAKING OR WARMING DRAWERS

APull the drawer out until it stops.

BLift the front of the drawer until the stops clear the guide.

Stop

CRemove the drawer.

8