Connections and Setup

Things to Consider Before You Connect

Protect Against Power Surges

Connect all components before you plug any of their power cords into the wall outlet.

Turn off the TV and/or components before you connect or disconnect any cables.

Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your DVD player.

Protect Components from Overheating

Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

Don’t stack components.

When you place components in a stand, make sure you allow adequate ventilation.

If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other components.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.

If you place components above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the back of the TV.

If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away from audio/video cables.

Connection Pictures

Audio/video cables are usually bundled together. For better visibility, the connection pictures in this book show each cable separately (audio left, audio right, and video).

Note: The illustrations in this book are representational, and in some instances may not exactly match the item represented.

Types of Discs Your DVD Player will Play

DVD video discs – DVD video discs contain high quality picture and sound content.

Audio discs – Audio CDs contain musical or sound content only.

Video CDs – Like DVD discs, VCDs contain picture and sound content. VCDs hold less content that DVD discs.

CD-R (MP3 files) – CD-R discs with MP3 files recorded or downloaded on them..

VIDEO CD

6 _______________________________________________________________ chapter 1