Caring for the dishwasher.

Safety Instructions

Operating Instructions

Spray Arms and Filters

The dishwasher will flush away all normal food soils. However, objects (fruit pits, bones, etc.) may collect in openings and should be removed occasionally to avoid clogging the drain system.

CAUTION: Personal

injury hazard. Before cleaning the interior, wait at least 20 minutes after a cycle for the heating element to cool down. Failure to do so could result in burn injuries.

Cleaning the Spray Arms

Because hard water chemicals will clog the spray arm jets and bearings, it is necessary to clean the spray arms regularly. To remove the spray arm, twist the retaining nut 90 degrees and pull the spray arm off the shaft.

Wash the arms in soapy, warm water and use a soft brush to clean the jets. Replace them after rinsing thoroughly.

Cleaning the Filters

For best performance and results, the filter assembly must be cleaned regularly. The filter efficiently removes food particles from the wash water, allowing water to be recirculated during the cycle. For this reason, it is a good idea to remove the large food particles trapped in the filter frequently by rinsing the main filter and cup under running water. To remove the filter assembly, pull up on the cup handle. The entire filter assembly should be cleaned at least once a month. To clean the main filter and fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the illustration and reinsert the entire assembly in the dishwasher, positioning it in place and pressing downward. The dishwasher must

never be used without the filters. Improper replacement of the filter may reduce the performance level of the appliance and may damage dishes and utensils.

Troubleshooting Tips

Retaining

Main filter

nut

 

 

Cup

Washer

Fine filter

 

Upper rack

Retaining nut

Support

Protect Against Freezing

If your dishwasher is left in an unheated place during the winter, ask a service technician to:

1Cut off electrical power to the dishwasher. Remove fuses or trip circuit breaker.

2Turn off the water supply and disconnect the water inlet line from the water valve.

3

4

Drain water from the water inlet line and water valve. (Use a pan to catch the water.)

Reconnect the water inlet line to the water valve.

Consumer

Air gap

Check the air gap any time your dishwasher isn’t draining well.

Does Your Dishwasher Have an Air Gap?

An air gap protects your dishwasher

The air gap is easy to clean.

against water backing up into it if a drain

 

Turn off the dishwasher and lift off the

clogs. The air gap is not a part of the

1

dishwasher. It is not covered by your

 

cover.

 

 

 

warranty. Not all plumbing codes require

 

Remove the plastic cap and clean with

2

air gaps, so you may not have one.

 

a toothpick.

 

10

Page 10
Image 10
GE GHDA696P, GHDA690P owner manual Spray Arms and Filters, Protect Against Freezing, Does Your Dishwasher Have an Air Gap?