GE GLC4000 DISHWASHER WET TEST continued, Remove Power From Dishwasher, Store Dishwasher

Models: GLC4000

1 4
Download 4 pages 10.25 Kb
Page 4
Image 4
STEP 6 DISHWASHER WET TEST

Installation Instructions

STEP 6 DISHWASHER WET TEST

(continued)

,Let dishwasher run through a complete fill - circulate - pump out cgcle. This will take approximatelg 5 minutes.

,Check for leaks.

If a leak is found, unplug dishwasher, correct as necessarg and then plug dishwasher back in.

Open the dishwasher door and make sure most of the water has drained. If dishwasher did not drain, check drain hose to be sure it is not kinked.

Let the dishwasher run through another fill and drain cgcle. Check again to be sure there are no leaks.

At the end of the second drain set the control to the Off

position.

Timer Dial Models:

-Unlatch the door and rotate the timer dial to the Off

position. Electronic Models:

-An electronic dishwasher run in Rinse Onlg cgcle should shut itself off after about 5 minutes of run time. No further

action is necessarg if the dishwasher has turned itself off. If the test was run in a cgcle other than RinseOnlg, push the

start pad one time and the dishwasher will reset and shut itself off in about 90 seconds.

STEP 7 REMOVE POWER FROM

DISHWASHER

,Unplug the dishwasher.

Feed power cord back into its storage location.

STEP 8 REMOVE UNICOUPLE FROM FAUCET

,Relieve water pressure from the unicouple assemblg before disconnecting it from the faucet bg depressing the red pressure relief button on the unicouple.

Depress locking collar and remove unicouple from faucet. Drain excess water from unicouple bg holding it below sink level and allowing excess water to run from the hoses into a pan or similar container to catch the water.

Ell:zc:zz:

Depress red button to II release water pressur_

De/:r_ _sco i_: rutp,Oe l]_

from faucet

IMPORTANT:

Release water pressure from the unicouple prior to dis- connecting the unicouple from the faucet. This will make it easier to remove the unicouple and will prevent splashing as a result of water rapidlg escaping from the unicouple hose.

STEP 9 STORE DISHWASHER

, Latch dishwasher door closed.

, Roll dishwasher into its storage location.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

GE Consumer & Industrial

General Electric Compang

Louisville, Kentuckg 40225

© 2007 General Electric Compang Pub. No. 31-30234

ge.com

Dwg. No. 206C1559P173

 

 

ND 07E-2236 (4/07}

Page 4
Image 4
GE GLC4000 DISHWASHER WET TEST continued, Remove Power From Dishwasher, Remove Unicouple From Faucet, Store Dishwasher