Using the water dispenser.
GXCF05D/GNCF04H
Floor model
GXCF20E/GXCF20FBB Chiller model
GXCC01D
Countertop model
Features and Parts List
Bottle Support Collar (WS28X10047), grey for models GXCF05D, GNCF04H and GXCC01D
Bottle Support Collar (WS28X10049), white for model GXCF20E, (WS28X10048) black for model GXCF20FBB
Separator (WS28X10013)
Cold Water Tank
Hot (Red) and Cold (Blue) Power Switches (back of dispenser). The Cold (Blue) power switch also turns on the chiller compartment (on model GXCF20E).
Indicator Lights. The green light will be lit when the dispenser is plugged in. The red and blue lights will cycle on and off while the dispenser heats and cools water. Compressor start delayed by up to 3 minutes.
Hot (Red) and Cold (Blue) Water Dispenser Buttons
Dispenser Drip Tray (WS28X10016) and Grille
(WS28X10015), grey for models GXCF05D, GNCF04H
and GXCC01D
Dispenser Drip Tray (WS28X10026) and Grille
(SW28X10027) white for model GXCF20E
Dispenser Drip Tray (WS28X10031) and Grille
(WS28X10034) black for model GXCF20FBB
Compartment Tray (model GXCF20E/GXCF20FBB only)
(WS29X10029)
Storage Compartment (GXCF05D and GNCF04H).
Do not use to store foods requiring refrigeration. The compartment is not refrigerated.
Chiller Compartment (GXCF20E). The compartment is intended solely for use in chilling canned and boxed beverages, and packaged nonperishables.
Compartment Shelf (WS28X10028)
Drainage Cap (floor and chiller models) (WS01X10008)
Silicon Stopper (floor and chiller models) (WS01X10007)
Retaining Clip (countertop models) (WS01X10010) 
Rubber Drain Cover (countertop models) (WS01X10011)
Loading the Dispenser and Start Up
Sanitize the dispenser water tanks prior to installing a full bottle of water for the first time (see “Cleaning and Sanitizing the Water Tanks”).
IMPORTANT: Make sure the dispenser is unplugged with both the hot and cold power switches (on the back of the dispenser, on models so equipped) set to the O (off) position. Before placing the water bottle on the dispenser, wash hands and wipe the top of the bottle with a clean cloth. Avoid touching the part of the bottle that will be in contact with the water dispenser.
Make sure the water level in the top of the dispenser is low enough to allow for proper bottle installation. Failure to do so may cause the dispenser to overflow.
1.Peel the label from the top cover of the bottle (if present). Do not remove the entire bottle cap.
2.Place the bottle on top of the dispenser as shown, aligning the dispensing valve probe to the center of the water bottle cap. Press down until the probe penetrates the bottle cap, allowing the bottle to rest on the support collar.
3.IMPORTANT: Press both dispense buttons until water runs from both taps.
4.Plug in the dispenser.
5.Set the COLD and HOT power switches (located on the top left rear of the dispenser, on models so equipped) to the I (on) position.
6.Allow 30 minutes for water to reach hot and cold temperatures.
Contact a local water bottle distributor to purchase water bottles.
4
