GE GNUL30Z installation instructions Tools And Materials Required For Installation

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

•Slotted and Phillips screw drivers

•Pliers and adjustable jaw wrench

•Hand or battery powered drill and 1⁄4″ bit (saddle valve installation)

•Electric drill and a drill bit to drill a 1⁄4″ hole (type as required) if a mounting hole is needed for the faucet

CAUTION: To avoid damaging the sink, consult a qualified plumber or installer for drilling procedures. Special drill bits may be needed for porcelain or stainless steel.

•Contents included with the product:

—Water filter assembly, including mounting bracket and screws

—Literature (installation instructions, owner’s manual, product data sheet, and owner product registration card)

—Water supply/saddle valve

—Filtered water faucet, for sink or countertop mounting including an electronic indicator faucet base and battery pack

—3⁄8″ tubing and fittings to make all needed connections

—Pipe joint sealant (Teflon Tape*) for fittings

—Sump wrench

INSTALLATION OVERVIEW

Locate the drinking water system on the cold water supply pipe, under the kitchen and/or bathroom sink, to filter the cold drinking water.

Fig. 1

							Washer
				Filtered water faucet
								Adapter
		Sink
									Nut
						Tubing
										Water
Battery pack
										out
					Water supply/saddle valve
	Hot		Cold

Shutoff valve

NOTE: To change the filter cartridge, you must turn off the water. A nearby shutoff valve is convenient. Most sinks already have shutoff valves on the supply pipes.

Water
	Mounting
in
	screw (2)

Insert

Nut

Tubing

Filter II

Filter I

NOTE: Be sure to allow a minimum space of 1-1⁄2″ under the system for removing the sumps, to change the cartridges.

2 *Teflon Tape is a Registered Trademark of Dupont