GE GNUL30Z installation instructions Electronic Faucet Installation, Tighten the nut until snug

ELECTRONIC FAUCET INSTALLATION

Be sure there is room underneath the sink to make the needed connections. Select one of the following places to install the faucet:

—IN an existing sink spray attachment or soap dispenser hole

—IN a hole to be drilled in the sink top

—IN a hole to be drilled in the countertop, next to the sink

NOTE: Looking at Fig. 3D, be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal. The base may have to be angled sideways or diagonally.

1.	If drilling is needed, make a 1-1⁄4″ dia. hole. Be sure to use the
	proper procedure for drilling porcelain or stainless steel. Special
	drill bits may be needed.
2.	Looking at Fig. 3A, insert a screw into the NON-SLOTTED base
	mounting hole. Turn a flat nut a few turns onto the screw.

Fig. 3A.	Fig. 3B.	Nut (2)
		TOP VIEW
	Screw (2)	Screw (2)
	Faucet
	base
	Faucet
	base
	Gasket	″
Nut (2)		1-1/4 dia. mounting
		hole in sink or

countertop

3.	Position the base gasket over the mounting hole. Set the base on
	the gasket, routing the leadwire through the mounting hole.
	Holding the flat nut under the sink with one finger, tighten the
	screw until just snug.
4.	Turn the remaining flat nut a few turns onto the other screw.
	Position the screw in the slotted base mounting hole and tighten
	until snug. Make sure the gasket position is properly aligned and
	carefully tighten both screws until the base is held firmly in place.
	Do not overtighten and break the base.
5.	Assemble the top faucet base and hex nut onto the faucet stud
	(Fig. 3C). Tighten the nut until snug.
6.	Insert washer into tubing adapter. Securely tighten to faucet stud.
7.	Put a few wraps of Teflon Tape* on the end of the faucet stud.
	Using the plastic washer, turn the tubing adapter onto the faucet
	stud and tighten securely.

Fig. 3C.

Spout

Lever

Faucet

Faucet stud

Top faucet base

ASSEMBLED

8.	Feed the length of 3⁄8″ OD tubing from the bottom, up through
	the faucet base. Connect to the tubing adapter as shown
	in Fig. 3C., tightening the compression nut securely.
9.	Remove the short shipping tube and insert the spout into the
	faucet body.
10.	Lower the faucet assembly and lock into place on the faucet base.

Fig. 3D.

Hex nut

Washer

Tubing

adapter

Compression

nut

Compression

nut

3/8″ tubing, (run to Filter 2 outlet)

Base leadwire connector

(to battery pack)

Faucet base

*Teflon Tape is a Registered Trademark of Dupont. 4