installation instructions
The installation of the side panel requires the panel support bracket to be mounted to the underside of the countertop and the toekick panel to be mounted to the floor. If the panel is installed perpendicular to a wall, the side panel will also be fastened to the wall.
The enclosure for the dishwasher must be at least 24" wide. The dimensions on the adjacent diagrams show locations of the screw holes for the toekick panel and the support bracket panel. Locating the screw holes as shown will provide the required 24" opening for the dishwasher.
The toekick panel is mounted with its 1" flange against the floor. Similarly, the panel support bracket is mounted with its 1" flange against the underside of the countertop.
STEP i ADJACENT CABINET SHOULD BE
SQUARE AND PLUMB FOR GOOD
DISHWASHER FIT
Check cabinet for perpendicularity to the floor with a carpenter'ssquare. If the cabinet is out of square, it may be necessary to make adjustments in the installation of this panel to ensure the dishwasher will fit properly in the opening.
\
STEP 2 LAY OUT MOUNTING HOLES FOR
TOEKICK PANEL
The
,\
lJ T
Note: Measurements are to Center of Holes
If the floor is ceramic tile, quarry tile or similar material, it wil! be necessary to drill clearance holes through the tile so lag bolts can be screwed into the
L | Figure A |
STEP 3 LAY OUT MOUNTING HOLES FOR
PANEL SUPPORT BRACKET
In the same manner as above and using the same dimensions, lay out the hole locations on the underside of the countertop. Use a punch to create a pilot hole or drill a pilot hole. However, when drilling pilot holes be extremely careful. Do not drill holes a!l the wag through the countertop.
Panel Support
Note: Measurements are to Center of Holes