Safety Instructions
Operating Instructions
Before you call for service…
Problem | Possible Causes | What To Do |
Dishes don’t dry | Low inlet water | • Make sure inlet water temperature is at least 120°F. |
| temperature | • Select HEATED DRY. |
|
| • Use HOT START and ADDED HEAT options. |
|
| • Select a higher cycle, such as POTS & PANS or HEAVY WASH. |
|
|
|
| Rinse agent dispenser | • Check the rinse agent dispenser and fill as required. |
| is empty |
|
|
|
|
Dishes and flatware | Inlet water temperature | • Raise the water heater temperature to 120°F. |
not clean | is below 120°F. | • Use HOT START, POTS & PANS or HEAVY WASH and HI TEMP WASH. |
|
|
|
| Too little detergent | • See Using the dishwasher section, refer to Proper Use of Detergent for |
|
| detergent recommendations. |
|
|
|
| Old or damp powdered | • See Using the dishwasher section, refer to Proper Use of Detergent for |
| detergent | detergent recommendations. |
|
|
|
| Water pressure is | • Turn on a faucet. Is water coming out more slowly than usual? If so, |
| temporarily low | wait until pressure is normal before using your dishwasher. |
|
|
|
| Air gap is clogged | • Clean the air gap. |
|
|
|
| Improper rack loading | • Make sure large dishware does not block the detergent dispenser or |
|
| the wash arm. |
|
|
|
| No air gap or high | • Verify that you have an air gap or a high drain loop. Refer to |
| drain loop | the Installation Instructions. |
Troubleshooting Tips
Spots and filming | Extremely hard water |
on glasses and | Low inlet water |
flatware | temperature |
| Overloading the |
| dishwasher |
| Improper loading |
| Old or damp powder |
| detergent |
| Rinse agent dispenser |
| empty |
| Too little detergent |
•Use
•To remove stubborn spots and
1 Remove all metal utensils from the dishwasher.
2 Do not add detergent.
3 Select the longest cycle.
4 Start the dishwasher and allow to run for 18 to 22 minutes. Dishwasher will now be in the main wash.
5 Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher.
6 Close the door and allow to complete the cycle. If vinegar rinse doesn’t work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar.
Consumer Support
Cloudiness on | Combination of soft | • This is called etching and is permanent. To prevent this from |
glassware | water and too much | happening, use less detergent if you have soft water. Wash glassware in |
| detergent | the shortest cycle that will get them clean. |
|
|
|
| Water temperature | • Lower the water heater temperature. |
| entering the dishwasher |
|
| exceeds 150°F. |
|
|
|
|
Detergent cup lid | Dial is not in the OFF | • Turn the Timer Dial to OFF. |
won’t latch | position |
|
|
|
|
Detergent left in | Dishes are blocking the | • Reposition the dishes. |
dispenser cups | detergent cups |
|
|
|
|
Steam | This is normal | • Steam comes through the vent by the door latch during drying and |
|
| when water is being pumped out. |
|
|
|
Black or gray | Aluminum utensils have | • Remove marks with a mild, abrasive cleaner. |
marks on dishes | rubbed against dishes |
|
12